How To Install Water Pressure Gauge On Yamaha Outboard. Yamaha's spec for minimum water pressure at normal operating speed is 11 psi. Put the water pressure gauge tubing into the tap and use the wrench to tighten the nut.
Installed the 't' fitting on water pee hose (as directed by several installation guides). I am back on the flush kit. Can i use the tale tell water discharge fitting on top of the block and eliminate the tale tell water stream, as i would now have a pressure reading instead?
Yamaha motors require 61886p adapter kit for installation. As the water pump wears out you notice variations of different pressures. Yamaha isn't any different from other engine makers.
Then it stayed stuck on 20. I've installed the gauge, ran the tubing, connected tubing and electrical for light/ground. All yamaha outboards have a minimum water pressure of eleven (11) psi at wide open throttle (wot).
Installed the 't' fitting on water pee hose (as directed by several installation guides). Locate the power bus where other instruments are connected. You then need a hose to the dash and a water pressure gauge.
You get water to the dash, so there is no need for a sensor. Run the other end of the water pressure gauge tube to the gauge. Loosen the screws on the bus, using a screwdriver, and push the spade terminal on the temperature gauge's power wire under the screws.
Take off the tap plug using the allen wrench. It was stuck on 0 using a flush kit, pee hole working well. The ecu can then display this data on the tachometer.
Comments
Post a Comment